填料塔中Na_2CO_3吸收高浓度H_2S的传质特性

在填料吸收塔中考察了Na2CO3溶液吸收高浓度H2S气体的气液传质特性。通过测量填料塔进出口气体中H2S浓度计算了Na2CO3溶液吸收高浓度H2S气体的总体积传质系数(KGa),并研究了进气流速、吸收液流量、吸收温度和吸收液浓度对KGa的影响。结果表明,KGa随Na2CO3浓度、吸收液流量的增加而增加,随吸收温度、进气流速的升高而降低;在高浓度H2S吸收过程中液相传质阻力不能忽略。     

煤化工企业火炬NOx排放的模拟燃烧实验

针对煤化工企业火炬气燃烧特点，设计了一套模拟燃烧装置，分别研究液化气添加量及燃烧温度对NOx的影响，并对火炬系统NOx的排放系数进行核算。结果表明，火炬系统NOx排放浓度和排放量随液化气添加量的增加而增大；同时研究发现，NOx与燃烧温度之间成正比关系，即温度升高有利于NOx的产生。根据核算结果，火炬系统NOx排放系数在0．099～0．185kg／t之间，平均为0．139kg／t。     

Physiological and antioxidative response of Brassica nigra (L.) to ZnO nanoparticles grown in culture media and soil

Abstract

To investigate metal nanoparticle-induced phytotoxicity, Brassica nigra seeds were exposed to 50–1000?mg L^?1 ZnO nanoparticles in culture media and 100–1000?mg kg^?1 in soil. Plant length and weight were adversely affected in culture conditions, but with soil the effect was not significant. Determination of the radical-scavenging potential revealed that soil grown plants were less stressed than plants grown on culture medium. The total antioxidant and reducing power potential of soil grown plants were less variable compared to plants grown on culture medium. Total phenolic and flavonoid concentrations varied in plants, which changed with the nanoparticle’s concentrations in medium and soil. High performance liquid chromatography analysis showed that rutin was the major antioxidative molecule that significantly increased in nanoparticles-stressed B. nigra plants.     

广州市生活垃圾高温有氧静态堆肥的生命周期分析

运用生命周期分析(LCA)方法,对广州市生活垃圾高温有氧静态堆肥系统进行分析,计算出全生命周期的资源消耗和环境影响潜值,同时与垃圾焚烧典型工艺的LCA数据进行对比。结果表明,堆肥处理的环境影响负荷为0.023PET90,资源消耗系数为9.238mPET90。环境影响类型中光化学臭氧合成造成的影响最大,占环境总影响的43.8%。与焚烧处理方式相比,高温有氧静态堆肥的环境总影响较小,环境影响负荷相比于焚烧减少20.3%,在降低酸化的影响方面有较为显著的作用。     

黄石市冬/春季大气PM_(10)中重金属形态特征研究

采用三级序列提取程序分离黄石市黄石港区、西塞山区、大冶市、阳新县PM10中的不同形态重金属,并使用电感耦合等离子体质谱对分离后液体中8种重金属(Cu、Cd、Zn、Cr、As、Pb、Ni、Co)的含量进行测定。同时,将传统金属生物有效性系数(k)进行加权,从而以重金属生物有效性综合系数(K)直观表征4个区域空气PM10中重金属对人体健康的危害程度。结果表明:(1)As为黄石市主要重金属污染物,冬季西赛山区As的质量分数为85.5%。(2)黄石港区PM10中冬季Cu、Zn、Cd、Pb和春季Cu、Cr、Pb,西塞山区PM10中冬季Cu、Zn、Cd、Pb、Ni、Co和春季Zn、Cd、Cr、Pb、Ni、Co,大冶市PM10中冬季Cu、Zn、Pb、Ni和春季Cd、As、Pb,阳新县PM10中冬季Zn、Cd、As、Pb和春季Zn、Cd、Pb,其k均大于0.2,对当地居民的健康存在潜在风险或风险。综合评价,阳新县冬季和大冶市春季的大气重金属污染较严重,其K分别为0.544和0.340,对人体健康风险较大。     

喷淋塔传质特性的实验与模型研究

从液滴受力分析入手,分析了喷淋塔内液滴的运动特性,采用类比定律推导了气相传质系数计算式,建立了喷淋塔脱氨传质模型,并进行了实验验证,分别在不同的喷淋密度和空塔气速的条件下,对传质系数、比表面积及容积吸收率沿塔高的分布进行了模拟.结果表明,沿着液滴的下落方向,比表面积逐渐减小,传质系数缓慢增大,二者在塔顶附近变化显著;传质速率受比表面积和传质推动力的影响较大,增大喷淋密度可显著增加比表面积,提高空塔气速可增大平均传质系数;喷淋塔下半段比表面积小,增大比表面积是强化传质的有效手段.     

Numerical study of choked two-phase flow of hydrocarbons fluids through orifices

Valves and orifices are the most widely devices of flow control used in oil and gas industry. In particular, they are installed in relief piping system in order to control the discharge flow during potential plant overpressuring scenarios, thus ensuring plant safety. It is a common practice to flow liquid and gas mixtures through such restriction devices.Rigorous models are available to precisely size pressure relief devices operating in single phase flow; however for two-phase flow, no models are considered sufficiently reliable for predicting the relevant flow conditions.In the present paper, two-phase flow of hydrocarbons fluids through an orifice under critical conditions has been numerically investigated.The existing literature has been analyzed and data on two-phase flow of highly volatile mixtures of hydrocarbons through openings have been collected. A comparison has been carried out with numerical simulations carried out by the multiphase flow simulation tool OLGA by SPT.The Henry–Fauske model has been used as orifice choke model and the orifice discharge flow coefficient, required as input by OLGA, has been calculated by Chisholm's model.Comparison between OLGA's results and experimental data shows that Henry–Fauske model markedly underestimates the mass flow rate through the orifice, if Chisholm's model is used to calculate discharge coefficient. It was found that the error of the model could be minimized using different values of orifice discharge coefficient (C_d).A new discharge flow coefficient model, suitable for choked two-phase flow across orifices, is proposed in this study and it has been determined to match the above mentioned experimental measurements.     

煤化工企业火炬 NOx排放的模拟燃烧实验简

针对煤化工企业火炬气燃烧特点，设计了一套模拟燃烧装置，分别研究液化气添加量及燃烧温度对NO_x的影响，并对火炬系统NO_x的排放系数进行核算。结果表明，火炬系统NO_x排放浓度和排放量随液化气添加量的增加而增大；同时研究发现，NO_x与燃烧温度之间成正比关系，即温度升高有利于NO_x的产生。根据核算结果，火炬系统NO_x排放系数在0.099~0.185 kg/t之间，平均为0.139 kg/t。     

分子电性距离矢量预测多氯萘的正辛醇/空气分配系数

应用分子电性距离矢量(MEDV)对多氯萘(PCNs)的76种同系物进行结构表征,通过多元线性回归方法建立了PCNs的正辛醇/空气分配系数(lgKoA)与MEDV之间的定量结构一性质关系(QSPR),该模型具有显著的相关性(n=24,R=0.997,SD=0.088,F=417.546).采用逐步回归的方法(SMR)从原...     

新型封孔材料的性能研究及封孔长度计算

研究聚氨酯硬泡材料的渗透性能和粘结性能,旨在为煤矿瓦斯抽放和煤层注水工艺提供本质安全型的封孔材料,从而提高瓦斯抽放和煤层注水的效果,做好瓦斯、煤尘灾害的预防工作。根据达西定律设计材料渗流量的测试实验,将测定的数据进行线性拟合后,得出聚氨酯硬泡材料的渗透系数为1.00546×10-6cm/s;通过材料的抗压剪切力测试,得出聚氨酯硬泡与煤的粘结强度为387.95kPa;根据封孔模拟实验结果,选择压注药液法作为封孔方法,并根据钻孔受力平衡原则,计算得出由聚氨酯硬泡作为封孔材料的封孔长度至少为0.967m。